♻️ Adjust LCD init, contrast default, settings load

Marlin/src/MarlinCore.cpp

@@ -1294,16 +1294,7 @@ void setup() {
   // UI must be initialized before EEPROM
   // (because EEPROM code calls the UI).
 
-  #if HAS_DWIN_E3V2_BASIC
-    SETUP_RUN(DWIN_Startup());
-  #else
-    SETUP_RUN(ui.init());
-    #if BOTH(HAS_WIRED_LCD, SHOW_BOOTSCREEN)
-      SETUP_RUN(ui.show_bootscreen());
-      const millis_t bootscreen_ms = millis();
-    #endif
-    SETUP_RUN(ui.reset_status());     // Load welcome message early. (Retained if no errors exist.)
-  #endif
+  SETUP_RUN(ui.init());
 
   #if PIN_EXISTS(SAFE_POWER)
     #if HAS_DRIVER_SAFE_POWER_PROTECT
@@ -1314,10 +1305,6 @@ void setup() {
     #endif
   #endif
 
-  #if ENABLED(PROBE_TARE)
-    SETUP_RUN(probe.tare_init());
-  #endif
-
   #if BOTH(SDSUPPORT, SDCARD_EEPROM_EMULATION)
     SETUP_RUN(card.mount());          // Mount media with settings before first_load
   #endif
@@ -1325,6 +1312,15 @@ void setup() {
   SETUP_RUN(settings.first_load());   // Load data from EEPROM if available (or use defaults)
                                       // This also updates variables in the planner, elsewhere
 
+  #if BOTH(HAS_WIRED_LCD, SHOW_BOOTSCREEN)
+    SETUP_RUN(ui.show_bootscreen());
+    const millis_t bootscreen_ms = millis();
+  #endif
+
+  #if ENABLED(PROBE_TARE)
+    SETUP_RUN(probe.tare_init());
+  #endif
+
   #if HAS_ETHERNET
     SETUP_RUN(ethernet.init());
   #endif