Bring configs up to date with 1.1.x

Marlin/src/config/examples/Velleman/K8400/Configuration.h

@@ -781,14 +781,14 @@
 
 // The size of the print bed
 #define X_BED_SIZE 200
-#define Y_BED_SIZE 180
+#define Y_BED_SIZE 200
 
 // Travel limits (mm) after homing, corresponding to endstop positions.
 #define X_MIN_POS 0
 #define Y_MIN_POS 20
 #define Z_MIN_POS 0
 #define X_MAX_POS X_BED_SIZE
-#define Y_MAX_POS ((Y_BED_SIZE) + (Y_MIN_POS))
+#define Y_MAX_POS Y_BED_SIZE
 #define Z_MAX_POS 190
 
 /**
@@ -1419,6 +1419,12 @@
 // Enable one of the following options to specify your controller.
 //
 
+//
+// Original RADDS LCD Display+Encoder+SDCardReader
+// http://doku.radds.org/dokumentation/lcd-display/
+//
+//#define RADDS_DISPLAY
+
 //
 // ULTIMAKER Controller.
 //
@@ -1715,9 +1721,9 @@
  * LED Type. Enable only one of the following two options.
  *
  */
-
 //#define RGB_LED
 //#define RGBW_LED
+
 #if ENABLED(RGB_LED) || ENABLED(RGBW_LED)
   #define RGB_LED_R_PIN 34
   #define RGB_LED_G_PIN 43
@@ -1728,11 +1734,11 @@
 // Support for Adafruit Neopixel LED driver
 //#define NEOPIXEL_LED
 #if ENABLED(NEOPIXEL_LED)
-  #define NEOPIXEL_TYPE   NEO_GRB  // NEO_GRBW / NEO_GRB - four/three channel driver type (defined in Adafruit_NeoPixel.h)
+  #define NEOPIXEL_TYPE   NEO_GRBW // NEO_GRBW / NEO_GRB - four/three channel driver type (defined in Adafruit_NeoPixel.h)
   #define NEOPIXEL_PIN    4        // LED driving pin on motherboard 4 => D4 (EXP2-5 on Printrboard) / 30 => PC7 (EXP3-13 on Rumba)
   #define NEOPIXEL_PIXELS 30       // Number of LEDs in the strip
   #define NEOPIXEL_IS_SEQUENTIAL   // Sequential display for temperature change - LED by LED. Disable to change all LEDs at once.
-  #define NEOPIXEL_BRIGHTNESS 255  // Initial brightness 0-255
+  #define NEOPIXEL_BRIGHTNESS 127  // Initial brightness (0-255)
   //#define NEOPIXEL_STARTUP_TEST  // Cycle through colors at startup
 #endif