Bring configs up to date with 1.1.x

Marlin/src/config/examples/FolgerTech/i3-2020/Configuration_adv.h

@@ -557,7 +557,7 @@
   #endif
 
   // Show a progress bar on HD44780 LCDs for SD printing
-  //#define LCD_PROGRESS_BAR
+  #define LCD_PROGRESS_BAR
 
   #if ENABLED(LCD_PROGRESS_BAR)
     // Amount of time (ms) to show the bar
@@ -659,7 +659,7 @@
 #if ENABLED(BABYSTEPPING)
   //#define BABYSTEP_XY              // Also enable X/Y Babystepping. Not supported on DELTA!
   #define BABYSTEP_INVERT_Z false    // Change if Z babysteps should go the other way
-  #define BABYSTEP_MULTIPLICATOR 16  // Babysteps are very small. Increase for faster motion.
+  #define BABYSTEP_MULTIPLICATOR   2 // Babysteps are very small. Increase for faster motion.
   //#define BABYSTEP_ZPROBE_OFFSET   // Enable to combine M851 and Babystepping
   #define DOUBLECLICK_FOR_Z_BABYSTEPPING // Double-click on the Status Screen for Z Babystepping.
   #define DOUBLECLICK_MAX_INTERVAL 1250 // Maximum interval between clicks, in milliseconds.
@@ -1391,7 +1391,7 @@
  * For clients that use a fixed-width font (like OctoPrint), leave this set to 1.0.
  * Otherwise, adjust according to your client and font.
  */
-#define PROPORTIONAL_FONT_RATIO 2.2
+#define PROPORTIONAL_FONT_RATIO 1.5
 
 /**
  * Spend 28 bytes of SRAM to optimize the GCode parser
@@ -1419,8 +1419,8 @@
   #define USER_DESC_4 "Heat Bed/Home/Level"
   #define USER_GCODE_4 "M140 S" STRINGIFY(PREHEAT_2_TEMP_BED) "\nG28\nG29"
 
-  #define USER_DESC_5 "Home & Info"
-  #define USER_GCODE_5 "G28\nM503"
+  //#define USER_DESC_5 "Home & Info"
+  //#define USER_GCODE_5 "G28\nM503"
 #endif
 
 /**
@@ -1531,7 +1531,7 @@
  * Fully assembled MAX7219 boards can be found on the internet for under $2(US).
  * For example, see https://www.ebay.com/sch/i.html?_nkw=332349290049
  */
-#define MAX7219_DEBUG
+//#define MAX7219_DEBUG
 #if ENABLED(MAX7219_DEBUG)
 //#define MAX7219_CLK_PIN   64  // on RAMPS       // Configuration of the 3 pins to control the display
 //#define MAX7219_DIN_PIN   57  // on RAMPS
@@ -1550,7 +1550,6 @@
    * If you add more debug displays, be careful to avoid conflicts!
    */
   #define MAX7219_DEBUG_PRINTER_ALIVE    // Blink corner LED of 8x8 matrix to show that the firmware is functioning
-
   #define MAX7219_DEBUG_STEPPER_HEAD  3  // Show the stepper queue head position on this and the next LED matrix row
   #define MAX7219_DEBUG_STEPPER_TAIL  5  // Show the stepper queue tail position on this and the next LED matrix row